|
Post by K6KD on Jul 1, 2017 11:16:29 GMT -8
The Modem corresponds to your radio, Fusion or DMR.
The Connector determines the connection to the YSF reflector.
Select Connector Type: System Fusion/YSFReflector
Modem Transmit/Receive Frequency
Select Server (or if not present first Add Server):
For example: US YSF002 / KingsOfDigital Port 42000
If adding a server not already in the list, the IP/Server name is needed: e.g. ysf002.dstar.club or ysf310.xrefl.net
Enter your call sign.
Leave everything as is and SAVE.
That's it!
|
|
|
Post by K6KD on Jul 1, 2017 13:08:55 GMT -8
The OpenSpot requires a direct connection to the internet via an ethernet RJ-45 connector. There are a number of options to use the OpenSpot when mobile. One such device listed below provides connectivity from an OpenSpot to a cell phone used as an access point to the internet. The OpenSpot connects via RJ-45 cable to the adaptor which has wifi capability to connect to the cell phone. Universal Wi-Fi N Adapter - Ethernet to Wi-Fi N 300Mbps www.iogear.com/product/GWU637/
|
|
|
Post by longboat on Oct 5, 2017 9:28:28 GMT -8
Guys I just bought a FT-70D. I can not tx on my Openspot. I use my Openspot already on D-Star and DMR with no issues. I must have some setting wrong on my FT70 like a default profile? I have the frequency set as simplex and DV mode. I can connect tp the Openspot C4FM.....FCS002/090 America link. I can hear QSOs but when I tx I just hear a hum. My Openspot does not show any connect on transmit. Any ideas? The FT70 transmits fine on FM and I have not been able to hit any Fusion repeaters using the DV mode. I programmed them in with the RT System software.
Any ideas would be appreciated.
WR3Y
|
|
|
Post by K6KD on Oct 5, 2017 18:57:03 GMT -8
KF9TA says in openSPOT Modem setting set C4FM-Half Deviation but first ensure you have latest firmware for the Yaesu radio. They strongly recommend the firmware update is done first.
|
|
|
Post by longboat on Oct 6, 2017 18:32:39 GMT -8
Half Deviation did not work. I updated the firmware and now I have a firmware error message when I power on. Not sure I grabbed the USA version. How do I start over, downgrade or do I try to upgrade the firmware again? Ugh
|
|
|
Post by K6KD on Oct 7, 2017 3:08:52 GMT -8
Half Deviation did not work. I updated the firmware and now I have a firmware error message when I power on. Not sure I grabbed the USA version. How do I start over, downgrade or do I try to upgrade the firmware again? Ugh Sorry to hear that half deviation did not help. Possibly because the correct firmware was not first installed. For openSPOT specific help, your best bet is at forum.sharkrf.com73 John K6KD
|
|