|
Post by K6KD on Jul 1, 2017 11:05:11 GMT -8
|
|
|
Post by N7SHG-Shelby on Dec 4, 2017 20:21:50 GMT -8
Looking for a place to join the new QRP Round Table on Monday evenings at 1900 Pacific Time, I am using Fusion via an SharkRF openSPOT. I was wondering if either of the YSF reflectors listed above will have that Round Table? I did NOT have any luck tonight (04DEC2017), BUT not entirely sure I have everything setup correctly. My other option may be to cross-mode to DMR in the openSPOT and then use a DMR reflector?
Shelby N7SHG
|
|
|
Post by K6KD on Dec 7, 2017 19:26:23 GMT -8
Hi,
Neither of the YSF reflectors are linked to the Round Table. There is an option with the openSPOT with its ability to convert System Fusion to DMR, and then connect via DMR. The audio levels between System Fusion and DMR are different so it is not perfect.
John K6KD
|
|
|
Post by N7SHG-Shelby on Dec 7, 2017 19:35:12 GMT -8
John, thanks, I need to figure out the details on that, I thought if it was on one of the two reflectors it would be easier to setup. I assume the DMR setup must be in the OpenSpot since there isn't a way to add TG, etc. from the Fusion radio. I have been able to talk on the BM TAC310 so I think a bit more learning to make this work.
|
|
|
Post by K6KD on Dec 7, 2017 19:53:47 GMT -8
Shelby,
I can't say for sure because I have only gone the other way with the openSPOT, i.e. using a DMR radio with the openSPOT to connect to a YSF reflector. There is a place in the DMR Connector to specify a Destination ID, so that may be the way to do it.
John
|
|
|
Post by N7SHG-Shelby on Dec 7, 2017 20:15:10 GMT -8
Currently listening to the net on a Yaesu Fusion HT, not sure it is a two way street yet, but making progress! So going from Fusion to DMR in the OpenSPOT and listening to XLX313.
N7SHG-Shelby
|
|
|
Post by K6KD on Dec 7, 2017 20:43:46 GMT -8
Good to hear!
|
|
|
Post by N7SHG-Shelby on Dec 7, 2017 21:10:36 GMT -8
Well failure on audio transmit, however my carrier and call is making it in, so just a bit more work. Strange that I can hear and net control could see my keyup, BUT no audio making it through. Unsure what else to change at this point...
EDIT to add I just did a test and working! I believe the issue was having the HT set to wide digital instead of narrow digital which I knew about BUT one of those things I just stared at and didn't see! The wide digital would still trigger the dashboard BUT the audio of course wouldn't make it, duh! On the Fusion digital you can talk either voice wide or narrow BUT not when crossing to DMR and I had been using Fusion mode last on the radio.
Bottom line is you can go from Fusion to the OpenSPOT where you can x-mode to DMR and from there onto the XLX313 reflector, so with this setup, Fusion, DMR and D-Star are all possible, pretty stoked to have all three modes from a single radio and the OpenSPOT!
SHG
|
|